hi there, thanks for picking up the batton. The project I'm building contains upto 60
slides, rather than use the playbar that comes with captivate I wanted to include my own which included= previous btn/forward btn/pause(not toggle, 2 separate btns)
mute btn/(2 seprate btns)and a replay btn.
Pause btn
When the pause btn is clicked it would show an animation swf(failed to animate)
but did appear when the pause btn was clicked on.
MUTE btn
As with the pause btn I wanted to do the same, once again the animation failed, but
did show when mute was clicked on
(using a supplied btn with image)
REPLAY btn
this was slightly different to the other buttons,
clicked on slide screen and applied the following:=Standard Action=
assign v_setframe with cpinfocurrentframe
then applied transparent btn with following=
assign cpcmdngotoframeAndresume with v_frame
this worked perfect and did what I wanted to do for each slide, when clicked it would replay with any problems..
when played in preview all tried out perfectly with any problems.
however when published as swf blank slides appeared after the first play.
tried publishing 2 or 3 times and there was a different result each time, sometimes it
will play upto 5 slides.
Just in case it was the replay btn causing the problem I saved the project as a trial
and took the replay off and republished, still same problem.
however i tried I played a project from captivate 5.5 and published, wallah! it published it without any blank slides.